Sheet in PA6.6 GF35 3000x500 mm natural

This is a sheet made of PA6.6 GF35, glass fiber reinforced polyamide 6.6 with 35 percent glass fiber.

The material is semi-crystalline and has a melting point of 254 °C.

The density is 1.40 g/cm³, the tensile strength 103 MPa and the tensile modulus 5500 MPa.

The elongation at break is 11 percent and Shore D 84. The continuous service temperature is 110 °C.

Used for gears, sprockets, slide strips, bearing bushings, wear plates and structural parts that need a little higher stiffness and heat resistance than PA6.

The plastic can be sawn, milled, turned and drilled with tools intended for engineering plastics. When milling, sharp inserts give a cleaner surface. Moisture affects the dimensions, so let the material rest in the workshop climate before final sizing.

This particular sheet in PA6.6 GF35 measuring 3000 x 500 mm in the color natural suits stiff structural parts such as fixtures, holders, spacers and wear surfaces under load. Cut to size on request.

Not sure whether the material suits your case? Get in touch with us.