Sheet in PA6.6 HS 2000x1000 mm brown

This is a sheet made of PA6.6 HS, polyamide 6.6.

The material is semi-crystalline and has a melting point of 261 °C.

The density is 1.15 g/cm³ and the moisture absorption at 23 degrees and 50 percent relative humidity sits at 2.5 percent.

The yield strength is 85 MPa, the elongation at break 55 percent and the tensile modulus 3274 MPa.

HS is a code that is not yet documented, so the remaining mechanical figures are based on standard PA6.6.

Used for gears, sprockets, slide strips, bearing bushings, wear plates and structural parts that need a little higher stiffness and heat resistance than PA6.

The plastic can be sawn, milled, turned and drilled with tools meant for engineering plastics. Sharp inserts give a cleaner surface when milling. Moisture affects the dimensions, so let the material rest in the workshop climate before the finishing cuts.

This particular sheet in PA6.6 HS measuring 2000 x 1000 mm in the color brown suits gears, slide strips, bearing bushings and wear plates where somewhat higher stiffness than PA6 is needed. Cut to size on request.

Not sure whether the material suits your case? Get in touch with us.