Sheet in PA6.6 GF50 3000x300 mm black

This is a sheet made of PA6.6 GF50, glass fiber reinforced polyamide 6.6 with 50 percent glass fiber.

The material is semi-crystalline and has a melting point of 256 °C.

The density is 1.61 g/cm³, the tensile strength 115 MPa and the tensile modulus 8700 MPa.

The elongation at break is 2 percent, the flexural strength 200 MPa and Shore D 90. The continuous service temperature is 130 °C.

Used for gears, sprockets, slide strips, bearing bushings, wear plates and structural parts that need a little higher stiffness and heat resistance than PA6.

The plastic can be sawn, milled, turned and drilled with tools meant for engineering plastics. Sharp inserts give a cleaner surface when milling. Moisture affects the dimensions, so let the material rest in the workshop climate before the finishing cuts.

This particular sheet in PA6.6 GF50 measuring 3000 x 300 mm in the color black suits stiff structural parts such as fixtures, holders, spacers and wear surfaces under load. Cut to size on request.

Not sure whether the material suits your case? Get in touch with us.